Pocket Conductivity Meter DiST 6

The floating waterproof Dist 6 measures conductivity and total dissolved solids. It features a dual level easy to read LCD display which shows the conductivity (or TDS) reading alongside the temperature reading. Packed with features such as adjustable TDS ratio, temperature readout in Centigrade or Fahrenheit, automatic calibration, automatic shut-off and battery life indicator, yet simple to use with only 2 fully sealed buttons. The combined conductivity/TDS sensor uses graphite modules which provide better repeatability than conventional sensors as they do not oxidise.

The sensor module is replaceable and can be ordered separately as a spare or replacement. The Dist 6 can be used with SP1 and SPR2

Pocket pH Meter pHep 4

The pHep 4 is our latest addition to the range of pH/Temperature measuring equipment and we at PRE-serve are delighted to be able to offer our customers this excellent tester for use with our products. The Phep’s ease of use in combination with its affordability made it possible for non–technical and technical personnel alike to measure pH on the spot, accurately and inexpensively. The pHep 4 includes features such as dual level LCD, battery level indicator, replaceable pH electrode cartridge, stability indicator. Automatic shut off and automatic calibration in a floating waterproof casing. The pHep 4 is suitable for use with the following PRE-serve products: OP1, OP3 and OW1.

Handheld pH Meter HI 98140

The HI 98140 is one of the most innovative portable PH meters ever offered. This instrument features IP67 waterproof protection, GLP (Good Laboratory Practice) capabilities, using the latest in electrode technology. The pH meter uses a chip that memorizes the calibration date and the data performed. This new technology allows the user to optimize time and efficiency with unsurpassed safety. It avoids erroneous measurements. The meter incorporates a temperature probe, eliminating the need for an additional temperature sensor. The unit features a dual level backlit LCD for dimly lit locations. Graphic symbols and messages guide the user through calibration and measurement. These advanced meters allow the user to set a calibration validity time and alerts the user when recalibration is necessary. Access to the GLP data is password protected for added safety. For use with: OP1, OP3 and OW1.

Handheld Conductivity Meter HI 9033

The HI 9033 has been proven time and again to hold up under extended use in the wet, humid, dusty and muddy conditions, The meter utilises a single probe to perform all conductivity readings in four ranges. This allows the user to measure samples from deionized water to brine without having to switch or recalibrate the probe. The meter performs measurements with ATC (automatic temperature compensation) which adjusts for the effects of temperature. This portable unit also features BEPS (Battery Error Prevention System) technology that alerts the user when low battery power could affect the readings. The HI 9033 can be used with SP1 and SPR2